Saving a set on stage
The needle breaks or the control record gives out mid-set. Dub is built so the beat doesn’t stop:1
Switch the deck to INT
The track keeps playing on Dub’s own clock from exactly where it was.
The deck stays on INT until you switch it back; the record can’t take it
over by accident.
2
Fix the needle or swap the record
Take your time. The set plays on.
3
Recalibrate while INT plays
Put the needle down on the turning record and press ↻. A lamp in the
TC segment shows the record’s state: amber while it measures,
green when it’s ready to take the deck back.
4
Switch back to TC
When the lamp is green, press TC. The record picks the track up
where INT has it, without a dropped beat.
The needle won’t lock
Open the deck’s SIGNAL panel and read its word:NO SIGNAL
NO SIGNAL
Nothing is arriving on that deck’s input. Is the needle down and the
record turning? Check the interface’s PHONO/LINE switch for that
input, and the cable.
WEAK
WEAK
One channel is low or the signal is noisy. The panel names the low
channel. Check that cable and the needle; a worn or dirty stylus does
this too.
NO LOCK
NO LOCK
Timecode is arriving but isn’t readable right now. That’s normal while
you scratch or when the record is stopped.
NO INPUT
NO INPUT
The deck has no input assigned. Pick one in Preferences ▸ Audio.
The fader is up but nothing comes out
Look at the deck’s output meter between the decks:- ECHO OUT: echo out is still on, and its tail has died away. The record plays on but nothing leaves the deck. Turn echo out off.
- NO OUTPUT: the deck has no output pair, or the audio engine isn’t running. Check Preferences ▸ Audio.
- The meter moves: Dub is sending. Check the mixer channel, its input selector and the cable.